Check
My
 Printer-Friendly(PDF) Coming soon! |
Change Language (Coming soon!)  |
Change Laptop |
 Link to This Step(step2) |
|||||||||||||||||
 |
||||||||||||||||||||
|
Click to enlarge
|
2: Remove Shell After removing each of the screws, starting at the bottom of each side of the display assembly, carefully start unsnapping the rear shell backing from the laptop. Usually it will easily snap off, as seen in the second picture. If it does not, work along the edges in different directions until it does, or look closely for overlooked screws. |
||||||||||||||||||
|
||||||||||||||||||||
|
You may click on any step in the left column to see it immediately. Below are simple links to all steps: |
|||||||||||||||||||
|
||||||
|
